DSLR Sensor Cleaning: How to Find and Remove Dust

This post deals with those annoying dark spots on the sensor (the matrix) – in other words, dust that has found its way inside the camera. I explain how it gets there, how to prevent it and how to clean it off.

Blue sky photo covered in dark specks from a dusty camera sensor

Overview

Key facts

  • Andrejs Zavadskis wrote this 2009 guide to how dust gets onto a DSLR sensor, how to spot it and how to remove it without harm.
  • Lens swaps let in most of the dust, so his advice is to change lenses seldom and with care, keeping the camera pointed upwards and staying away from dusty places.
  • A dust test means shooting a smooth white wall from 0.5-1 m, manually focused at infinity, at the smallest aperture the lens offers.
  • At f/2.8 dust hardly shows, while at narrow apertures like f/16 it is obvious; the sensor itself must never be blown with air.
  • In 2009 a professional clean at the Canon service centre in Riga cost about €28–43; when cleaning yourself, charge the battery fully and try dry methods before wet ones.

Where the Dust Comes From

Landscape photo with a magnified dust spot visible in the blue sky
Most of the time, dust enters the camera when you swap lenses. So my first piece of advice is to change lenses as seldom as you can. When you do, hold the camera facing upwards, work slowly and carefully, and preferably avoid dusty surroundings. Dust can also find its way in through gaps around the body and the buttons, although how much depends on how well the camera is sealed against it. On top of that, dust tends to collect on the rear of a lens, where it meets the camera; when the lens is mounted, some of that dust falls onto the mirror and later reaches the shutter and the sensor too. For this reason, always put the rear cap on whichever lens you are not using. From time to time it is worth blowing the dust off the mirror with an air blower bulb (the mirror is visible as soon as you take the lens off), but never, ever blow air at the sensor: the dust is pushed further in, behind the electronics, and sooner or later it lands on the sensor again. That is why the only cleaning methods I recommend are those that take dust out of the camera rather than driving it deeper inside.
If you notice mid-shoot that the sensor is carrying a lot of dust, switch to a wider aperture (F/2.8, say). Stopping down further (to F/11, for instance) makes the dust ever more visible. A small speck is practically invisible at F/2.8, yet photograph a landscape with a clear sky on a sunny day at F/16 and the dust shows up very plainly.
 

How to Check Your Sensor

Typically the dust reveals itself just when you are shooting something that matters, but you can find out beforehand whether your sensor is clean. Here is how, step by step:
1. Pick the lens with the longest zoom range you own (a 70-300mm, for example) and/or the one that stops down the furthest. Many macro lenses, for instance, go down to F/45, while ordinary lenses usually stop at F/22. Mount that lens on the camera.

2. Look for the smoothest white or grey wall you can find, inside or outside.

3. Put the camera in manual focus. Dial in the largest f-number it allows (F/16, F/22, F/29, ...) – that is, the smallest aperture – and turn the focus ring to infinity.

4. Take a picture of the wall from up close (0.5-1m), taking care not to overexpose it. It is fine if the exposure stretches to several seconds.  The result should be a blurry, light grey frame; zoom in on the camera screen or open it on a computer and study it closely. A dusty sensor will produce an enlarged image like this one:
Close-up of a white wall test shot showing dark sensor dust spots

Dealing With Dust

Step one in the battle is prevention: swap lenses as rarely as you can, and carefully, so that no dust gets in. Should you discover during a shoot that the sensor is badly dusty, use a wider aperture such as F/2.8; the more you stop down (F/11, for example), the more the specks stand out. A modest speck is next to invisible at F/2.8, but as soon as you shoot an outdoor scene with a clear sky at F/16, it is plain to see. Cameras' built-in dust removal systems do a passable job: they shake off some of the dust, though not all of it. Bear in mind, too, that the dust they shake off stays inside the camera, waiting for a chance to land back in your pictures.
Ideally, cleaning should be left to the professionals at the Canon service centre (IB SERVISS Maskavas 40, tel. 67204080). The cleaning alone may cost about €28–43, and the camera can take several days to come back. If you find you still swap lenses a lot, you can clean the sensor on your own. In that case, though, read this whole article and the comments under it, since overlooking a single detail can ruin your gear. Doing it yourself means paying extra for cleaning supplies and accepting the risk of damaging the camera. Before you begin, be sure to charge the battery fully; original batteries are recommended. There have been cases where the power ran out, or the user made a careless move, and the shutter and mirror snapped shut with the cleaning tool still inside the camera. The outcome can be a new mirror mechanism, a new shutter, or even a new filter in front of the sensor. Always start with dry cleaning, ideally a method that does not touch the sensor at all, and turn to wet cleaning only if the dirt stays put, because touching the sensor too often may scratch it. If you go for wet cleaning, double-check that the fluid is suitable for your camera's sensor: some combinations are incompatible, and the fluid can strip the sensor's protective coating together with the dust. More about fluids and sensors here: http://photosol.com/cameras_bymfg.html and http://bythom.com/cleaning.htm
Take care: you alone are responsible for your equipment while cleaning, and no warranty will bail you out. Below is a video showing what I use and roughly how the cleaning goes:
 

Cleaning Video


Cleaning Tools and Where to Buy Them

Brush – any art supply shop sells them. Get a good-quality one with natural bristles, and wash it very thoroughly and for a long time so that no powder is left in the hairs!!!
Electric brushes, sadly, cannot be bought in Latvia yet; you can find out more about them here -> www.visibledust.com
Sensor Swab products are on sale here -> www.reidlimaging.eu
Locally, wet and dry brushes, blower bulbs and other cleaning supplies are available from the MasterFoto store -> http://www.mdfoto.lv/?do=0&in=1&inc=3

Compatibility Tables

Below are two tables showing which fluids and tools suit each camera model.
 

Camera model
Level 1
Level 2
Level 3
Level 4
D1, D1h, D1x, D2h, D2hs, D2x, D50, D70, D100, D200, every Fujifilm body Air blower Sensor Brush or an Arctic Butterfly Sensor Swab 2 used with Dust Aid Ultra Clean (or Eclipse) Sensor Swab 2 made extra wet with methanol, then level 3 once more
Kodak Pro 14n, SLRn Air blower Sensor Brush or an Arctic Butterfly Sensor Swab 3 used with Dust Aid Ultra Clean (or Eclipse) Sensor Swab 2 made extra wet with methanol, then level 3 once more
D2xs, D70s, D40, D40x, D80 Air blower Sensor Brush or an Arctic Butterfly Sensor Swab 2 used with Dust Aid Ultra Clean (or E2) Cleaning by Nikon
D90, D300, D5000 Built-in sensor cleaning Sensor Brush or an Arctic Butterfly Sensor Swab 2 used with Dust Aid Ultra Clean (or E2) Cleaning by Nikon
D700 Built-in sensor cleaning Sensor Brush or an Arctic Butterfly Sensor Swab 3 used with Dust Aid Ultra Clean (or E2) Cleaning by Nikon
D3, D3x Air blower Sensor Brush or an Arctic Butterfly Sensor Swab 3 used with Dust Aid Ultra Clean (or E2) Cleaning by Nikon


Updated 21 July 2009
Brand
Camera
Swab type
Fluid: Eclipse or E2
       
 
Canon EOS 5D Mark II (FL)*
3
Eclipse
Canon EOS 50D (FL)*
2
Eclipse
Canon EOS 5D
3
E2
Canon EOS 350D
2
Eclipse
Canon EOS 10D
2
Eclipse
Canon EOS 1D
1
Eclipse
Canon EOS 1D Mark II
1
Eclipse
Canon EOS 1D Mark IIn
1
Eclipse
Canon EOS 1D Mark III
1
E2
Canon EOS 1Ds
3
Eclipse
Canon EOS 1Ds Mark II
3
Eclipse
Canon EOS 1Ds Mark lII
3
E2
Canon EOS 20D
2
Eclipse
Canon EOS 300D
2
Eclipse
Canon EOS 30D
2
Eclipse
Canon EOS D30
2
Eclipse
Canon EOS 500D (FL)*
2
Eclipse
Canon EOS D60
2
Eclipse
Canon Rebel (original)
2
Eclipse
Canon 400D Rebel Xti
2
E2
Canon Rebel XSi
2
E2
Canon 40D
2
E2
Canon 450D Xsi
2
E2
Canon 1000 Xs
2
E2
*Sensor with a fluoride coating
     
 
Contax N Digital
3
Eclipse
     
 
Fuji Finepix S1 Pro
1
Eclipse
Fuji Finepix S2 Pro
1
Eclipse
Fuji Finepix S3 Pro
1
Eclipse
Fuji Finepix S5 Pro
2
Eclipse
     
 
Kodak DCS 14n
3
Eclipse
Kodak DCS 760
1
Eclipse
Kodak DCS SLR/c
3
Eclipse
Kodak DCS SLR/n
3
Eclipse
Kodak DCS620
1
Eclipse
Kodak DCS620X
1
Eclipse
     
 
Konica Minolta Maxxum 5D
2
Eclipse
  Maxxum 7D
2
Eclipse
     
 
Leica M8
1
E2
Leica DMR
3
Eclipse
     
 
Nikon D1
2
Eclipse
Nikon D100
2
Eclipse
Nikon D1H
2
Eclipse
Nikon D1X
2
Eclipse
Nikon D200
2
Eclipse
Nikon D2H
2
Eclipse
Nikon D2Hs
2
Eclipse
Nikon D2X
2
Eclipse
Nikon D2Xs
2
E2
Nikon D3
3
E2
Nikon D3x
3
E2
Nikon D300
2
E2
Nikon D40
2
E2
Nikon D40X
2
E2
Nikon D50
2
Eclipse
Nikon D500
2
E2
Nikon D60
2
E2
Nikon D70
2
E2
Nikon D70s
2
E2
Nikon D700
3
E2
Nikon D80
2
E2
Nikon D90
2
E2
     
 
Olympus E3
2
E2
Olympus E300
2
Eclipse
Olympus E1
2
Eclipse
Olympus E410
2
E2
Olympus E450
2
E2
Olympus E510
2
E2
     
 
Panasonic Lumix DMC-L10 
2
E2
     
 
Pentax *ist DL
2
Eclipse
Pentax *ist DS
2
Eclipse
Pentax *ist D
2
Eclipse
Pentax K100D
2
Eclipse
Pentax K10D
2
E2
Pentax K200d
2
E2
Pentax K20d
2
E2
     
 
Sigma SD9
1
Eclipse
Sigma SD10
1
Eclipse
Sigma SD14
2
Eclipse
     
 
Sony DSLR-A100
2
E2
Sony DSLR-A200
2
E2
Sony DSLR-A300
2
E2
Sony DSLR-A350
2
E2
Sony DSLR-A700
2
E2
Sony DSLR-A900
3
E2

Next frame

Keep reading

All stories

Camera Buying Guide: From Compacts to Medium Format

A practical guide to cameras. Picking a camera is one of the toughest decisions any photographer faces, so here I explain how the main types differ, what each one is built for and how to choose the right one for yourself.

Comments 10

  1. padoms#10
    And under no circumstances should you clean the sensor with liquid meant for lenses. It will end very tragically.
  2. Silvis#9
    Does anyone know whether anyone in Latvia professionally cleans lenses?
  3. Александр#8
  4. Edijs#7
    At first, Andrej, I thought you were sitting there in your underwear telling all this :) :) :)
  5. Valts#6
    A voice for a ruble :D
  6. KKTK#5
    Thanks for the tip about electrifying the brush with compressed air - I really did not know that. That will be useful, because otherwise it is a pain to dig out those little dust particles. But unfortunately for me there are still a couple of burned-on spots on my sensor that even the official service could not clean off :/
  7. Jānis#4
  8. elina#3
    I also have those swabs and the electric one, they are OK. They remove everything that needs to be removed.
  9. LafFoto#2
    It seems that the official Sensor Swab brush distributors are also right here in Lithuania ;-):

    http://www.sergita.lt/lt/gamintojai/photosol/
  10. versatile#1
    I have bad experience - while cleaning the sensor I managed to scratch the sensor filter. One scratch, but a long one. So I would recommend the wet method only as the very last resort, and only after everything that can be wiped or vacuumed off is already gone. In my case a harder dust particle had remained near the edge of the sensor, and the result is clearly visible at f/11.

Leave a comment

Questions, corrections and your own experience are welcome. Your e-mail is never published.

(email will not be published)
Links are not allowed in comments
one plus four =* (in words)